User Tools
cisco:labs:00500
Table of Contents
Lab 00500 EIGRP 2 Routers, IOS-XE
Router 1
en conf t router eigrp 1 network 1.1.1.1 0.0.0.0 network 12.0.0.1 0.0.0.0
Router 2
en conf t router eigrp 1 network 2.2.2.2 0.0.0.0 network 12.0.0.2 0.0.0.0
Verification
r1#ping 2.2.2.2 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 2.2.2.2, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/3 ms
r1#show ip route | b Gate
Gateway of last resort is not set
1.0.0.0/32 is subnetted, 1 subnets
C 1.1.1.1 is directly connected, Loopback0
2.0.0.0/32 is subnetted, 1 subnets
D 2.2.2.2 [90/130816] via 12.0.0.2, 00:01:46, GigabitEthernet1
12.0.0.0/8 is variably subnetted, 2 subnets, 2 masks
C 12.0.0.0/24 is directly connected, GigabitEthernet1
L 12.0.0.1/32 is directly connected, GigabitEthernet1
r1#show ip eigrp nei
EIGRP-IPv4 Neighbors for AS(1)
H Address Interface Hold Uptime SRTT RTO Q Seq
(sec) (ms) Cnt Num
0 12.0.0.2 Gi1 11 00:02:34 2 100 0 4
r1#show ip eigrp topology
EIGRP-IPv4 Topology Table for AS(1)/ID(1.1.1.1)
Codes: P - Passive, A - Active, U - Update, Q - Query, R - Reply,
r - reply Status, s - sia Status
P 12.0.0.0/24, 1 successors, FD is 2816
via Connected, GigabitEthernet1
P 2.2.2.2/32, 1 successors, FD is 130816
via 12.0.0.2 (130816/128256), GigabitEthernet1
P 1.1.1.1/32, 1 successors, FD is 128256
via Connected, Loopback0
r1#show ip eigrp interfaces
EIGRP-IPv4 Interfaces for AS(1)
Xmit Queue PeerQ Mean Pacing Time Multicast Pending
Interface Peers Un/Reliable Un/Reliable SRTT Un/Reliable Flow Timer Routes
Gi1 1 0/0 0/0 2 0/0 50 0
Lo0 0 0/0 0/0 0 0/0 0 0
r2#ping 1.1.1.1 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 1.1.1.1, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/3 ms
r2#show ip route | b Gate
Gateway of last resort is not set
1.0.0.0/32 is subnetted, 1 subnets
D 1.1.1.1 [90/130816] via 12.0.0.1, 00:04:33, GigabitEthernet1
2.0.0.0/32 is subnetted, 1 subnets
C 2.2.2.2 is directly connected, Loopback0
12.0.0.0/8 is variably subnetted, 2 subnets, 2 masks
C 12.0.0.0/24 is directly connected, GigabitEthernet1
L 12.0.0.2/32 is directly connected, GigabitEthernet1
r2#show ip eigrp nei
EIGRP-IPv4 Neighbors for AS(1)
H Address Interface Hold Uptime SRTT RTO Q Seq
(sec) (ms) Cnt Num
0 12.0.0.1 Gi1 11 00:04:38 1 100 0 3
r2#show ip eigrp topology
EIGRP-IPv4 Topology Table for AS(1)/ID(2.2.2.2)
Codes: P - Passive, A - Active, U - Update, Q - Query, R - Reply,
r - reply Status, s - sia Status
P 12.0.0.0/24, 1 successors, FD is 2816
via Connected, GigabitEthernet1
P 2.2.2.2/32, 1 successors, FD is 128256
via Connected, Loopback0
P 1.1.1.1/32, 1 successors, FD is 130816
via 12.0.0.1 (130816/128256), GigabitEthernet1
r2#show ip eigrp interfaces
EIGRP-IPv4 Interfaces for AS(1)
Xmit Queue PeerQ Mean Pacing Time Multicast Pending
Interface Peers Un/Reliable Un/Reliable SRTT Un/Reliable Flow Timer Routes
Gi1 1 0/0 0/0 1 0/0 50 0
Lo0 0 0/0 0/0 0 0/0 0 0
TCL Script
r1#tclsh
r1(tcl)#foreach ipaddr {
+>(tcl)#12.0.0.2
+>(tcl)#2.2.2.2
+>(tcl)#} { ping $ipaddr }
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 12.0.0.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 2.2.2.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
r1(tcl)#tclquit
r2#tclsh
r2(tcl)#foreach ipaddr {
+>(tcl)#12.0.0.1
+>(tcl)#1.1.1.1
+>(tcl)#} { ping $ipaddr }
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 12.0.0.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/2 ms
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 1.1.1.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
r2(tcl)#tclquit
cisco/labs/00500.txt · Last modified: by Name
